Page 1 of 1

5X Mach3 Control Enclosure

PostPosted: Thu May 15, 2014 4:57 pm
by bjmxr88
Decided to make a neat enclosure for the Mach3 5 Axis Breakout Board and drivers. The enclosure has spots for all 5 driver boards, but my current setup only needs 4. All the ports are accessible as well as a built in fan to exhaust any heat from inside the enclosure. This was all done on a 60W Laser Cutter from Acrylic Plastic. Very happy with the results and it should keep things clean and safe.
20140515_114939.jpg

20140515_114944.jpg

Re: 5X Mach3 Control Enclosure

PostPosted: Thu May 15, 2014 4:59 pm
by bjmxr88
20140515_115104.jpg

20140515_115118.jpg

Re: 5X Mach3 Control Enclosure

PostPosted: Sat Aug 23, 2014 6:50 pm
by Alchemist
Great job ! I used an old Xbox console for mine.

Re: 5X Mach3 Control Enclosure

PostPosted: Thu Sep 25, 2014 9:44 am
by johntech
That looks really good. I need to make something for my old original controller and power supply along with the few other upgrades I added

John